The short version
- 1Your AC removes litres of moisture a day. That water has to go somewhere, and leaks mean the drain path is blocked or badly sloped.
- 2A clogged drain pipe is the most common cause and is usually cleared in minutes.
- 3A leak that starts suddenly after switching off often means the coil was freezing. Treat the cause, not just the drip.
- 4Cassette and ductable units depend on drain pumps and proper slope. Get them checked during every service.
Your AC isn't just a cooler. It's a dehumidifier too. On a muggy monsoon day, a single 1.5-ton split can pull several litres of water out of the air. That condensate drips into a tray under the coil and flows out through a thin drain pipe. When any part of that path fails, water ends up on your wall, your sofa or your false ceiling.
The usual suspects
A clogged drain pipe
Dust from the coil, algae and even small insects (wasps love drain pipes) build a sludge that slowly blocks the line. Water backs up into the tray and overflows from the front of the unit. This is by far the most common cause we see.
Wrong slope on the drain
Drain water flows by gravity. If the pipe was routed flat, or runs uphill anywhere, water sits and eventually overflows. This is an installation issue and often shows up in the first monsoon after a new AC goes in.
The unit isn't level
If the indoor unit tilts even slightly away from the drain side, water pools at the wrong end of the tray and spills. A spirit level check takes thirty seconds.
A frozen coil thawing out
If there's a flood of water right after you switch the AC off, the coil was probably icing up while running. When it thaws, more water comes off than the tray can handle. The real problem is low airflow or low refrigerant (see our AC not cooling guide).
Failed drain pump (cassette and ductable units)
Ceiling-mounted cassettes often lift water with a small pump before it drains by gravity. When that pump or its float switch fails, water drips through the ceiling tiles. You'll usually see a brown ring on the gypsum first.

What you can do right now
Quick checks
- Switch the AC off and put a towel under the unit
- Clean the filters. A dirty filter can cause icing, then leaking
- Find the outdoor end of the drain pipe and check that water drips out when the AC runs
- Check the pipe isn't kinked, crushed or dipping in a U-shape anywhere you can see
- Make sure the drain pipe's end isn't sitting in a puddle or blocked by a pot
How we fix it
Most leaks are a single visit. We flush the drain line with water and a blower or nitrogen, clean the tray, check the unit's level, and re-slope or re-route the pipe if the original installation was wrong. For cassettes, we test the drain pump and float switch and replace them if needed.
The best prevention is simple: include a drain flush in every service, and in commercial buildings, add drain line inspection to the quarterly AMC checklist.
