Step 1

Find the code

You searched for "Mitsubishi ductable AC E6 error code". Start by confirming exactly what your unit shows and where.

  • The wired remote controller, which usually displays the code
  • The indoor unit's lamp blink pattern, if the unit has no display
  • The outdoor unit's board lamp for outdoor-side faults
  • The unit's manual or label, which names the series and the code table
Step 2

Safe checks before you call

These are checks anyone can do without opening the unit. Do not open panels or touch wiring.

  • Switch the unit off at the controller, wait five minutes, then restart once. A one-off glitch after a power dip may clear. If the code returns, stop and note it.
  • Check the filters and return grille are clean and not blocked.
  • Check the outdoor unit is running and its air intake and discharge are not blocked.
  • Check the isolator or MCB has not tripped. Do not keep resetting a breaker that trips again.
  • Look for water at the drain outlet or around the indoor unit.
  • Make sure the supply and return grilles and any volume dampers are open.
  • If more than one zone or unit shows a fault, suspect the power supply or a shared control line before a single unit.
Step 3

Fault groups behind codes on a ductable ac

We do not list code-by-code meanings here because they differ by series, controller and software version, and a wrong table leads to the wrong fix. Use your manual's table for the exact meaning. These are the groups of faults that codes on this kind of unit usually fall into:

Communication faults

Indoor and outdoor units or the remote controller not communicating, often a wiring or connector issue.

Sensor faults

A temperature or pipe sensor reading out of range.

Airflow and fan faults

A blocked filter, closed dampers, a failing blower motor or a long, restricted duct run.

Drain faults

A blocked drain line or a tripped drain safety.

Compressor protection

Overload, pressure or temperature protection from low gas, a dirty coil or poor airflow.

Power supply

A voltage or phase issue stopping the unit from starting.

Step 4

What to tell us when you call

Note thisWhy it helps
Model number and series (nameplate)Lets us look up the correct code table and parts.
The exact code and where it appearsRemote, controller or lamp pattern changes the meaning.
When it appearsOn start, after some minutes, or after rain or a power dip.
What the unit doesNot cooling, no fan, water leak or full shutdown.
Recent eventsPower cuts, cleaning, relocation or a repair.
More help

Related pages

Mitsubishi Electric AC service

Our service-only page for Mitsubishi equipment.

Ductable AC by tonnage

Sizing and models.

AC repair

Our repair process.

FAQs

Common questions

It depends on the series and controller. Check the code table in your manual. Send us the model number and what the unit does when the code appears and we will tell you what to check.

Code still showing?

Send the model number and the code. We reply within 24 hours and will tell you what to check next.